Precision Dicing Saw for 6" , 8" , 10" , 12" Wafer Cutting for PCB, Silicon, Wafer

DS820 Precision Dicing Saw can be widely used for a variety of processing requirements. DS820 uses DS-200 software control system, touch screen control and GUI interface so that the image alignment of workpiece is simple and convenient. DS820 has stable performance and low failure rate. DS820 is applicable to the cutting process of blue glass, silicon, GaAs, PCB, ceramic, sapphire, crystal, lithium niobate, alumina and quartz.

Features

1. Available for workpiece with the dimension of 210 x 210mm
2. Available for cutting large-size square-chip and small size multi-chip materials
3. Cutting range can be adjusted based on needs to improve production efficiency
4. Reasonable structure
5. Low failure rate
6. Convenience for maintenance

 
• Use clean, oil-free air (dew point below -15, residual oil: 0.1 ppm, and filtration rating: 0.01μm/99.5 % or more).
• Keep room temperature fluctuations within ±1ºC of the set value (Set value should be between 20ºC - 25ºC), indoor humidity no more than 80% and no condensation.
• Keep cutting water and cleaning water 2ºC above room temperature (fluctuations within ±1ºC). Keep temperature of cooling water the same as room temperature.
• The machines should be used in an environment, free from external vibration. Do not install machine near a ventilation opening, heat generation equipment or oil mist generating parts.
• This machine uses water. In case of water leakage, please install the machine on the floor with sufficient waterproofing and drainage treatments.
• Please follow the product manual of our company.

About Us:







Certifications:


FAQ:
1.    Q: Are you manufacturer or trading company?
        A: We are manufacturer which focuses on Pressure Sensor for 33 years.
2.    Q: What international certificates do you have?
        A: ISO9001, CE, RoHS Certificated.
3.    Q: What is your production capacity?
        A: We produced 1500000 pieces pressure sensor in year 2017.
4.    Q: What is the lead time of your product?
        A: Stocks are available for some products. The typical lead time is 8~14 working days for product without customization. 
       Note: lead time may vary base on different products. Please contact us for detailed lead time. 
5.    Q: What is the warranty of your products?
       A: Our warranty time is 18 months after shipment.
6.    Q: Do you provide customized products?
       A: Yes, we can laser mark your logo, model and product information according to your requirement. We provide OEM and ODM service.